Filter
Top Products
9
ENGLISH
During playback
Specify how many tunes ahead or before
the current tune the tune you want is
located.
To locate a tune ahead of the
current tune on the tape
To locate a tune before the
current tune on the tape
Each time you set the tune, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback starts
from the beginning of that side.
– If the tape is fast forwarded to the end, it is reversed
and played from the beginning of the other side.
• In the following cases, the Multi Music Scan function
may not operate correctly.
–Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
–Tapes with short non-recorded sections.
–Tapes with high level noise or humming between
tunes.
Other convenient tape functions
Prohibiting tape ejection
You can prohibit the tape ejection and can “lock” a
tape in the cassette compartment.
Press and hold TAPE 23 and 0 for more than 2
seconds. “NO EJECT” flashes on the display for
about 5 seconds, and the tape is “locked.”
To cancel the prohibition and “unlock” the tape,
press and hold TAPE 23 and 0 for more than 2
seconds again. “EJECT OK” flashes again for about
5 seconds, and this time the tape is “unlock.”
Skipping the blank portions on the tape
You can skip blank portions between the tunes.
(Blank Skip)
When this function is on, the unit skips blank
portions of 15 seconds or more, fast-forwards to
the next tune, then starts playing it.
1.Press and hold SEL (select) for more than 2
seconds.
2. Select “B. SKIP (blank skip)” with ¢
or
4
.
3. Select the desired mode with the control dial.
The Blank Skip mode alternates between on and
off.
ON Ô OFF
Note:
When the tape reaches its end while fast-forwarding, the
tape direction will be changed automatically.
Repeat Function
Press the RPT button while a tune you would like
to hear over again is being played back. When the
tape reaches the end of the tune, the tape is
automatically rewound to the beginning of that tune
and playback resumes from there. This operation
will be repeated till the RPT button is pressed again.
Notes:
In the following cases, the Multi Music Scan, and Repeat
function mechanisms may not operate correctly. These
are NOT malfunctions; use the mechanisms to suitably
accommodate the materials and situations.
• Tapes with tunes having long pianissimo passages (very
quiet parts) or non-recorded portions during tunes.
• Tapes with tunes recorded at low recording levels.
• Tapes with short non-recorded sections.
• Tapes with high level noise or humming between tunes.
EN08-09KS-FX611[U]-9 11/1/01, 3:17 PM9