E - 8
Monitor
CONTROL REFERENCE GUIDE
1) MONITOR ON / OFF switch
2) STANDBY indicator
The LED will illuminate when the monitor is in
standby mode.
3) Screen
4) Remote sensor
Receives the remote control signal.
5) Speaker
6) VOLUME control
7) SCREEN switch
WIDE: Wide Screen
NORMAL: Pan screen
8) COLOR control
Adjust for color intensity.
9) BRIGHTNESS control
Adjust the lightness or darkness of the color.
10) Headphone / Earphone jack
11) Built-in EZ CABLE CONNECT TO MAIN UNIT
port (Input)
Installation of Monitors
• Use supplied mounting straps to install the monitors onto the seat back in a car.
2) Tightly wrap the mounting
strap around the headrest.
SAFETY WARNING!
• This unit should never be used by the vehicle's driver or left unsecured in the vehicle while driving.
• If this unit is being used in your vehicle, be sure that it is secured or held safely, and does not obstruct
any safey device, including air bags or seat belts.
• All passengers should wear seat belts when using this unit in a moving vehicle.
• If in doubt, please contact your vehicle manufacturer for further advice.
1) Loop the safety band around
the headrest.
1
3
2445 6
7891011
Mounting
Strap
Elastic
Safety Band