Filter
Top Products
English
|
29
Initial settings
You can congure initial settings of this unit.
Select the Standby source.
Refer to <Source selection> (page 10).
Press and hold the [AUDIO] button.
Enter the Function setting mode.
Use the [Control knob] to select “INITIAL SET”.
For how to use the [Control knob], refer to <How to
select the item> (page 9).
Use the [Control knob] to select an Initial
setting item.
Display Description
“PRESET TYPE”
Sets the Tuner preset type.
“TYPE NORMAL”: 1 station can be assigned to
1 preset button in each of 4 bands (FM1, FM2,
FM3, and AM), i.e., a total of 24 stations (6
stations x 4 bands) can be preset.
“TYPE MIX”: A total of 6 stations can be
assigned to a total of 6 preset buttons
regardless of band (FM1, FM2, FM3, and
AM). You can recall a preset station without
switching between bands.
“KEY BEEP”
Setting the operation check sound (beep
sound) ON/OFF.
“ON” / “OFF”
“PANDORA SRC”
Sets whether to display Pandora during source
selection.
“ON” / “OFF”
“AHA SRC”
Sets whether to display aha during source
selection.
“ON” / “OFF”
(Function of DPX-U5130BT)
“BUILT-IN AUX”
Sets whether to display AUX during source
selection.
“ON” / “OFF”
“CD READ”
Sets the method for reading CD.
When unable to play a special format CD, set
this setting to “2” to force playing. Note that
some music CDs may be unplayable even
when set to “2”.
In addition, audio files cannot be played when
set to “2”. Normally, keep this set to “1”.
1: Automatically distinguishes between the
audio file disc and music CD when playing
a disc.
2: Forces playing as a music CD.
“SWITCH PREOUT”
Switches the preout between rear output and
subwoofer output.
“REAR”: Rear output
“SUB-W”: Subwoofer output
(Function of DPX-U5130)
“SP SELECT” Sets the speaker type so that the System Q
value is optimal.
“OFF”: OFF
“5/4”: For 5 & 4 in. speaker
“6*9/6”: For 6 & 6x9 in. speaker
“O.E.M.”: For the OEM speaker
“F/W UPDATE” Upgrades the firmware.
When the firmware version appears, press
[Control knob].
Selecting “YES” and then pressing the [Control
knob] starts upgrading the firmware.
For how to update the firmware, access our
web site.
http://www.kenwood.com/cs/ce/
( : Factory setting)
Use the [Control knob] to select a setting.
The previous item appears.
Exit the Function setting mode.
Press and hold the [6] button.
13-2DIN_M_EN_00.indb 29 12/11/26 15:59