Kenwood KDC-W7037 Car Stereo System User Manual


 
8
|
English
General features
Volume
Increasing Volume
Turn the [VOL] knob clockwise.
Decreasing Volume
Turn the [VOL] knob counterclockwise.
Attenuator
Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, the "ATT" indicator
blinks.
Audio Control
1 Select the source to adjust
Press the [SRC] button.
Refer to <Selecting the Source> (page 7).
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Rear Volume "REAR VOLUME" 0 — 35
Subwoofer level "SUB-W LEVEL" –15 — +15
System Q "USER"/"ROCK"/
"POPS"/"EASY"/
"TOP40"/"JAZZ"/
"NATURAL"
User/Rock/
Pops/Easy/
Top 40/Jazz/
Natural
Bass level* "BASS LEVEL" –8 — +8
Middle level* "MIDDLE LEVEL" –8 — +8
Treble level* "TREBLE LEVEL" –8 — +8
Balance "BALANCE" Left 15 — Right 15
Fader "FADER" Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
* Source tone memory: Puts the set up value in the
memory per source.
About System Q
• You can recall the best sound setting preset for different
types of music.
• Change each setting value with the <Speaker Setting>
(page 9). First, select the speaker type with the Speaker
setting.
• "USER": The ranges selected lastly for Bass level, Middle
level, and Treble level are recalled automatically.
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and [ATT]
button.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1 Select the source to adjust
Press the [SRC] button.
Refer to <Selecting the Source> (page 7).
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Front High Pass Filter "HPF-F Fc" Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter "HPF-R Fc" Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter "LPF-SW Fc" 50/60/80/100/120/Through Hz
Subwoofer Phase "SW PHASE" Reverse (180°)/ Normal (0°)
Volume offset "VOL-OFFSET" –8 — ±0 (AUX: -8— +8)
Loudness "LOUD" OFF/ON
Dual Zone System "2 ZONE" OFF/ON
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones
during low volume. (Only the low tone is
compensated for when the tuner is selected
as a source.)