Filter
Top Products
54
|
KDC-X896/ KDC-BT852HD/ KDC-X496/ KDC-452U/ KMR-550U
English
|
55
Contents
Bluetooth setup
Function of KDC-X896, KDC-BT852HD
Bluetooth detail setting
You can configure the initial settings of this unit.
Enter the Bluetooth mode
Press the [ ] button.
“BT MODE” is displayed.
Enter the Function setting mode
Press and hold the Control knob.
Select the Detailed Settings item
Select the following items using the Control
knob.
“Settings” > “Detailed Settings”
Select a desired Bluetooth detail setting item
Turn the Control knob to select a Bluetooth
detail setting item, and then press the Control
knob.
Display Description
“Detailed Settings”
“Auto Answer”
Automatically answers a call after lapse of the
preset time interval.
“OFF”: Does not answer the phone call
automatically.
“0SEC”: Automatically answers the phone
call at once.
“1SEC” – “8SEC” – “99SEC”:
Automatically answers the phone call after
lapse of 1 – 99 seconds.
“Auto Reconnect”
When set to “ON”, starts re-pairing with the
registered Bluetooth device automatically
when it becomes unpaired.
“ON” / “OFF”
“Bluetooth HF/
Audio”
Specifies the output speakers for hands-free
voice communication and Bluetooth audio
sound.
“Front” : Outputs sound from the front
speakers.
“All” : Outputs sound from the front and rear
speakers.
“Call Beep”
Sets whether to output a beep from the
speaker when a call comes in.
“ON” : Outputs a beep.
“OFF” : Does not output a beep.
“MIC Gain”
Adjusts the sensitivity of the microphone for
telephone call or adjusts the voice of the caller.
“1” – ”20” – “30”
“NR Level”
Reduces the noise generated by the
surrounding environment without changing
the microphone volume or adjusts the voice
of the caller when it is not clear. Setting to
a positive (+) value enhances the noise
reduction effect.
“-1” – ”0” – “+1”
“Echo Cancel Level” Sets the echo cancellation level.
“-1” – ”0” – “+1”
( : Factory setting)
Select a Bluetooth detail setting value and
determine it
Turn the Control knob to select desired setting,
and then press the Control knob.
The previous item is displayed.
Exit the Function setting mode
Press and hold the [ ] button.