Filter
Top Products
English
|
11
System Q
You can recall the best sound setting preset for
different types of music.
1 Select the source to set
Press the [TU/SR] or [CD/CH] button.
2 Select the Sound type
Press the [Q] button.
Each time the button is pressed the sound
setting switches.
Sound setting Display
Flat "Flat"
User memory "User"
Rock "Rock"
Pops "Pops"
Easy "Easy"
Top 40 "Top40"
Jazz "Jazz"
• User memory: The values set on the <Audio Control>
(page 11).
Audio Control
1 Select the source for adjustment
Press the [TU/SR] or [CD/CH] button.
2 Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3 Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
4 Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display Range
Bass Center Frequency* "Bass F" 60/70/80/100 or 150 Hz
Bass level "Bass" –8 — +8
Bass Q Factor* "Bass Q" 1.00/1.25/1.50/2.00
Bass Extend* "Bass EXT" ON/OFF
Middle Center Frequency* "MID F" 0.5/1.0/1.5/2.0 kHz
Middle level "Middle" –8 — +8
Middle Q Factor* "Middle Q" 1.0/2.0
Treble Center Frequency* "TRE F" 10.0/12.5/15.0/17.5 kHz
Treble level "Treble" –8 — +8
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
Sub woofer level* "SW Level" –15 — +15
Front High Pass Filter* "HPF F" Through/100/125/
170 Hz
Rear High Pass Filter* "HPF R" Through/200 Hz
Front/Rear High Pass
Filter*
"HPF" Through/100/125/170
Hz
Sub woofer Low Pass
Filter*
"LPF SW" 50/80/120/THRU Hz
Volume offset "V-Offset" –8 — ±0
Loudness "LOUD" ON/OFF
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• Volume offset: Each source’s volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
• * You can control this item when <Switching preout>
(page 23) is set to "SWPRE Sub-W". (KTS-300MR only)
• *
2
Function of the KTS-MP400MR
• *
3
Function of the KTS-300MR
5 Exit Audio Control mode
Press the [AUD] button.