Filter
Top Products
Accessories/ Installation Procedure
Accessories
➀
..........1
➁
..........1
➂
..........1
➃
..........2
➄
..........4
➅
..........1
➆
..........1
➇
..........1
Installation Procedure
1. To prevent a short circuit, remove the key from
the ignition and disconnect the - battery.
2. Make the proper input and output wire
connections for each unit.
3. Connect the speaker wires of the wiring harness.
4. Connect the wiring harness wires in the
following order: ground, battery, ignition.
5. Connect the wiring harness connector to the
unit.
6. Install the unit in your vessel.
7. Reconnect the - battery.
8. Press the reset button.
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the negative ground point, you may cause a
short circuit, that in turn may start a fire. Always connect
those wires to the power source running through the fuse
box.
• If your vessel ignition does not have an ACC position,
connect the ignition wire to a power source that can be
turned on and off with the key or other control switch. If
the receiver is left on for an extended period of time the
battery may die.
• If the fuse blows, first make sure the wires aren’t touching
to cause a short circuit, then replace the old fuse with
one with the same rating.
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not remove
the caps on the ends of the unconnected wires or the
terminals.
• Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or fail
to work if you share the - wires or ground them to any
metal part in the vessel.
• When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals
(do not mix front and rear). For example, if you connect
the + connector of the left speaker to a front output
terminal, do not connect the - connector to a rear
output terminal.
• After installing the unit, check to make sure that electrical
equipment such as the signal lamps and gauges operate
normally.
• Mount the unit so that the mounting angle is 30° or less.
English
|
29