Kompernass KH 2375 Car Stereo System User Manual


 
- 9 -
Face plate
Putting the face plate on
Place the face plate with the left side in the frame
first. Then firmly press the right side until it locks
into place.
Check to make sure that the face plate is firmly
and correctely installed in the frame. If the face
plate is incorrectely installed it can result in mal-
functions when operating the car radio.
Removing the face plate
Press the button to unlock the face plate.
To remove the face plate first tip it slightly forward
and pull the right side away first and then the left
side.
Note
When the face plate is not inserted into the frame
the theft protection LED on the device blinks.
To safeguard the face plate always keep it stored
in its case.
Remote control
Inserting the battery
Remove the supplied battery from the packing.
To insert the battery and/or change the battery
proceed as follows:
Pull the battery compartment out of the remote
control by first pressing the lateral locking device
and then pulling the battery compartment out.
Remove the depleted battery and insert a new
battery of the type CR2025 (Button cell) into the
battery compartment. Make sure that the battery
is inserted in accordance with its correct polarity.
Slide the battery compartment back into the re-
mote control.
Using the remote control
Point the remote control to the Infrared sensor
on the front panel of the device.
You can use the remote control for distances of
up to approx. 8 m from the device.
IB_KH2375_VY3995_LB3A 23.04.2008 10:51 Uhr Seite 9