Kompernass KH 2375 Car Stereo System User Manual


 
- 7 -
Configuration of the ISO connections
Of course you can also only connect the car radio
to two speakers. Then you only use the cable for the
front speakers.
Problems because of cable interchanging
In a few vehicle models the standard configura-
tion of the connections [4] and [6] in the ISO
Block A (see above "Configuration of the ISO
Blocks") is interchanged at the factory. If this is
the case the station memory can be lost.
To correct this the connections 4 (Ignition positive)
and 6 (Permanent positive) in the ISO Block A must
be swapped.
Installing the radio into the ISO duct
Note
Before installation remove, without fail, the two
transport securing screws on the top of the radio
housing (marked with a red sticker)!
1234
5678
ISO A
Configuration
1 unconfigured
2 unconfigured
3 Antenna power
4 12 V (Ignition
positive)
5 unconfigured
6 Permanent positive
7 unconfigured
8 Minus (-)
1234
5678
ISO B
Configuration
1 Rear right +
2 Front right +
3 Front left +
4 Rear left +
5 Rear right -
6 Front right -
7 Front left -
8 Rear left -
The car radio can be installed into any standard
ISO mounting duct. In the event that your vehicle
does not have an ISO mounting duct contact your
local specialist establishment, local dealer or the
technical department of the store.
Pull the installation bracket and the bezel frame
off of the car radio's housing.
Place the installation bracket into the ISO mounting
duct.
Bend the tabs on the installation bracket with a
screw driver so that the bracket is fixed firmly
into the mounting duct (see diagram).
Check to make sure that the bracket is securely
fixed.
Connect the ISO socket block of the car radio with
the two ISO plugs on your vehicle.
Connect the antenna cable from the vehicle an-
tenna to the antenna socket on the car radio.
Feed the microphone unit cable into the mounting
duct and connect it to the microphone unit socket.
Run the cable in such a way that the microphone
unit can later be secured in the vehicle interior.
Contingently connect the audio cinch cable of
an external amplifier to the
LINE OUT socket on the
car radio.
If necessary secure your device against theft
with additional measures. Attach the securing
screw with the anchoring plate and the securing
material to the engine firewall of the vehicle.
Carefully push the car radio into the mounting
duct until it locks into place. Finally put on the
bezel frame.
IB_KH2375_VY3995_LB3A 23.04.2008 10:51 Uhr Seite 7