LG Electronics 39LP645H Car Satellite TV System User Manual


 
54
206-4232
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
TV Connections
Make these connections ONLY after Master TV Setup and TV cloning procedures are
complete.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
INTERFACE port on the TV’s rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio
connectors, as applicable, for the cable bundle.
Reference: Remote Jack Pack / TV Connections & Setup
093 RJP AVAILABLE 001
ANTENNA/
CABLE IN
RGB IN (PC)
TV-LINK
CFG
AUDIO IN (RGB/DVI)
SPEAKER OUT
LINE OUT
PTC SERVICE
(SERVICE ONLY)
RJP
GAME CONTROL
/MPI
RS-232C IN
(SERVICE ONLY)
/
DVI
IN
1
2
..........
..........
VIDEO
L/MONO-AUDIO-R
AV IN
L R
RESET
UPDATE
OPTICAL
AUDIO OUT
HDMI/DVI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP
Connect RJ-45
Control cable from
RJP cable bundle.
RGB IN (PC)
Connect RGB connector from RJP
cable bundle (legacy RJP only).
AUDIO/VIDEO IN
Connect Composite Video/
Audio connectors from RJP
cable bundle. (Composite
Video on legacy RJP only.)