2
Notes on Installation
Before You Install
Remove the Old Unit from the Dashboard
Disconnect negative battery terminal before starting installation. Consult the vehicle's owner's
manual for proper instruction.
The unit is designed for a 12Volt DC negative ground operation system only. Before Installing
the unit, make sure your vehicle is a 12Volt DC negative ground system.
Be sure to connect the leads according to the diagram. Incorrect connections may cause the
unit to malfunction or damage the vehicle's electrical system.
Be sure to connect the negative (-) speaker leads to the negative (-) speaker terminal. Never
connect negative (-) speaker leads to chassis ground.
The unit is only designed for use with 4 speakers. Do not combine output for use with 2
speakers. Do not ground negative speaker leads to the chassis ground.
Make sure all of the connections are completely correct before turning on your unit.
When replacing the fuse(s), the replacement must be of the same amperage as shown on
the fuse holder.
Do not block vents or heater panels. Blocking them will cause heat to build up inside and
may result in fire.
After completing the installation and before operating the unit, reconnect the battery. Then
press the (RESET) button with a pointed object, such as a ball-point pen to set the unit to its
initial status.
Automotive audio equipment installations can be troublesome at times, even to the
most experienced of installation technicians. If you are not confident working with
electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or
other components of your vehicle, please call your dealer in order to have the unit
professionally installed.
IMPORTANT :
Due to protection of CD Mechanism, the two small
transport screws on the top of the unit must be
released before installing the unit.
Otherwise, the CD Mechanism can not be working
properly.
1. Remove front control panel.
2. Slightly insert release keys into the slot and
gently to release.
3. Separate the holder from the unit.
Keep release keys in a safe place as
you may need for future removal of unit.
RELEASE KEY
RELEASE KEY
transport screws
