Nextar N CU 160 Car Stereo System User Manual


 
4
Wiring Connections
Make sure that you have a good chassis ground. Good ground connections will eliminate
most electrical noise problems. A good chassis ground requires a tight connection to the
vehicle's metal chassis. The area around the ground connection should be clean, bare
metal without rust, paint, plastic, dust, or dirt for a good electrical connection.
This unit is designed for use with four (4) speakers with an impedance between 4 ohms
to 8 ohms.
An impedance load of less than 4 Ohms could damage the unit.
Never bridge or combine the speaker wire outputs. When not using four speakers, use
electrical tape to tape the ends of the unused speaker outputs to prevent a short circuit.
Never ground the negative speaker terminals to chassis ground.
Speaker Wiring Notes
Follow the above wiring diagram to install the head unit with new or existing speakers.
Care of Discs
Handle the disc by its edge to keep the
disc clean. Do not touch the disc’s surface.
Do not use CDs with labels or stickers
attached. The label may leave a sticky
residue when it begins to peel.
Clean the discs with an optional cleaning cloth.
Wipe each disc from
the center out.
Do not use a CD with paste or ink residue
on it.
POWER
ANTENNA
IGNITION
RED
FUSE 1A
BLUE
ANTENNA
GRAY
GRAY/BLACK
PURPLE
PURPLE/BLACK
BLACK
YELLOW
GROUND
MEMORY
FUSE 8A
FRONT LEFT SPEAKER
REAR LEFT SPEAKER REAR RIGHT SPEAKER
FRONT RIGHT SPEAKER
RCA
LINE OUT
GREEN
GREEN/BLACK
WHITE
WHITE/BLACK