Filter
Top Products
3
Installation
DIN FRONT DASH MOUNT
DIN REAR-MOUNT ISO (Remove facia and surround until fitting completed)
Note: The mounting box, outer trim ring, and half-sleeve are not used for ISO installation.
1
4
3
3
2
2
Installation the unit
1. Dashboard.
2. Holder
3. Screw
After inserting
the holder into
the dashboard,
select the
appropriate tab
according to the
thickness of the
dashboard material
and bend them inwards to
secure the holder in place.
1. Dashboard.
2. Plain washer
3. Spring washer
4. Self-Tapping screw
5. Screw
6. Strap
Be sure to use the strap to
secure the back of the unit
in place. The strap can be
bent by hand to the desired
angle.
6
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
1. Select a position where the screw holes of the bracket
and the screw holes of the main unit become allgned
(are fitted), and tighten the screws at 2 places on
each side.
2. Screw
3. Radio mounting bracket (not provided with radio)
4. Dashboard or Console
Use either truss screws (5X6mm) or flush surface
screws (4X6mm), depending on the shape of the
screw holes in the bracket.
Removing the unit
1. Frame
2. Insert fingers into the groove in the front of
frame and pull out to remove the frame,
(When re-attaching the frame, point the side
with a groove downwards and attach it.)
3. Release keys
Insert the keys supplied with the unit into the
grooves at both sides of the unit as shown in
figure until they click. Pulling the keys make
it possible to remove the unit from the dashboard.