Onkyo CR-525UKD Car Stereo System User Manual


 
6
Before Using the CD receiver
In general, the illustrations in this Instruction Manual show the CR-425UKD/CR-325UKD.
Notes:
If the remote controller doesn’t work reliably, try replac-
ing the batteries.
Don’t mix new and old batteries or different types of bat-
teries.
If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from leak-
age or corrosion.
Expired batteries should be removed as soon as possible
to prevent damage from leakage or corrosion.
When you operate the remote controller, point it at the
CD receiver’s remote control sensor, as shown below.
Notes:
The remote controller may not work reliably if the CD
receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in mind
when installing.
If another remote controller of the same type is used in
the same room, or the CD receiver is installed close to
equipment that uses infrared rays, the remote controller
may not work reliably.
Don’t put anything, such as a book, on the remote con-
troller because the buttons may be pressed inadvertently,
thereby draining the batteries.
The remote controller may not work reliably if the CD
receiver is installed in a rack behind colored glass doors.
Keep this in mind when installing.
The remote controller will not work if there’s an obstacle
between it and the CD receiver’s remote control sensor.
Installing the Batteries
1
Detach the battery cover by pressing the
tab and pulling up the cover.
2
Insert two batteries (R6/AA) into the bat-
tery compartment.
Carefully follow the polarity diagram (positive
(+) and negative (–) symbols) inside the battery
compartment.
3
After the batteries are installed and
seated correctly, attach the compartment
cover.
Using the Remote Controller
A
p
p
r
o
x
.
5
m
Remote control sensor
CD receiver