Filter
Top Products
26
En
OSD (ON SCREEN DISPLAY) LANGUAGE
Select the desired language for on screen menus of the
unit from the following:
(European and North American)
`ENGLISH
`FRANÇAIS
`DEUTSCH
`ITALIANO
`ESPAÑOL
(Hong Kong)
`English
`Chinesetrad
SCREEN SAVER
`ON:
The screen saver starts up if nothing is played back
and no operations are performed for 4 minutes.
`OFF:
The screen saver does not start up.
DIVX CODE
(excluding North American models)
`OK:
Display the DivX
®
registration code.
DIGITAL AUDIO SETUP
■ DIGITAL OUTPUT
`OFF:
Select this when you do not use the COAXIAL
DIGITAL AUDIO OUT jack.
No signal is output from this jack.
`ALL:
Select this when the unit is connected to an audio
component equipped with a built-in Dolby Digital
decoder via the COAXIAL DIGITAL AUDIO OUT
jack.
`PCM only:
Select this when the unit is connected to an audio
component such as amplifier/receiver, CD recorder
or MD deck via the COAXIAL DIGITAL AUDIO
OUT jack.
DOLBY DIGITAL SETUP
■ DUAL MONO
`STEREO:
Left channel is output from the left speaker, and right
channel is output from the right speaker.
`L-MONO:
Left channel is output from the front left and right
speakers.
`R-MONO:
Right channel is output from the front left and right
speakers.
3D PROCESSING
■ REVERB MODE
This setting provides following sound effects:
`OFF
`CONCERT
`LIVING ROOM
`HALL
`BATHROOM
`CAVE
`ARENA
`CHURCH
• This function is effective only when playing back a DVD
disc recorded with Dolby Digital. This control has no
effect on other discs.
• The overall effect of this setting depends on the disc
being played, the amplifier, and the speakers used for
playback.
NIGHT MODE
`ON:
Applies dynamic range control to Dolby Digital
material, reducing the volume of loud sounds, and
increasing the volume of quiet ones. This is useful
for spoken word material, and nighttime listening
etc.
`OFF:
Turns off the audio dynamic compression.
• This function is effective only when playing back a DVD
disc recorded with Dolby Digital. This control has no
effect on other discs.
• The overall effect of this setting depends on the disc
being played, the amplifier, and the speakers used for
playback.
AUDIO SYNC
This setting can cause delays in the sound signal in 10 ms
increments ranging from 0 ms to 200 ms (only for digital
signals recorded on a disc or stored in a USB drive;
unavailable for analog signals coming from LINE 1 or 2).
Depending on the TV, it may take approximately 100 ms
(0.1 sec.) for an image to appear after video signals are
input, causing the image to appear after the sound coming
from the unit is heard.
• If this happens or audio and video synchronization
creates a less than optimal viewing experience, adjust the
delay using (decrease) or (increase).
AUDIO SETUP