Filter
Top Products
29
En
Listening to the FM Radio
Listening to the FM Radio
Selecting stations which cannot be tuned automatically
(Manual selection)
When TUNING is pressed momentarily, the
frequency changes by a fixed step.
Press TUNING repeatedly until the station you want
to listen to is found.
FM MODE
Pressing FM MODE alternates between Auto mode and
Mono mode.
■ Auto Mode
FM stereo or monaural broadcasts are received in the
same mode as the signal.
■ Mono Mode
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced to monaural,
reducing unwanted noise.
If the reception is poor
For the best reception, rotate the FM antenna until you get
stations clearly.
You can store up to 20 FM stations.
Automatic Memory Presetting
Manual Memory Presetting
How to select preset stations
The Radio Data System (RDS) is a broadcasting service
which allows stations to send additional information along
with the regular radio programme signal.
1
Press FM to select “FM Radio”.
2
Hold down TUNING for more than 1 seconds
to select the station you want to listen to (Auto
selection).
When a station is tuned in, the tuning process will
stop automatically.
Repeat this step until the station you want to listen to
is found.
• If you want to stop the tuning process, press
TUNING .
Preset Tuning
1
Press FM to select “FM Radio”.
2
Press SEARCH.
Up to 20 of the received stations in your area will be
stored automatically.
1
Tune in a station.
2
Press MEMORY.
3
Select a preset channel to store the station using
PRESET , and then press MEMORY.
1
Press FM to select “FM Radio”.
2
Select a preset channel using PRESET .
• You can also select a preset channel by using
PRESET on the unit.
RDS (Display Setting of the FM)
– excluding North American models
1
Tune in an FM RDS station (see “Listening to the
FM Radio”).
2
Press DISPLAY.
Each time DISPLAY is pressed, the RDS mode is
changed as follows:
■ PS (Programme Service name)
Automatically displays the FM station name when
PS data is received.
■ PROG TYPE (Programme Type)
Displays the programme type. If there is no PTY
data, “NO PTY” will be displayed.
■ RDS CLOCK
Displays the information about times provided
from the station.
If there is no time data, “NO CT” will be
displayed.
RDS only works in areas where RDS broadcasts are
available.