Filter
Top Products
Optional Wall-mounting Kit (KX-B063)
39
Installation Manual
English
■ Wall-mounting procedure
1
Confirm that the wall is strong enough to support the weight of the electronic board.
The wall must be capable of supporting at least
2,010 N [205 kgf (452 lbs.)] for UB-7320.
2
Tape the Wall-mounting template on the wall.
• Do not use the template included in the wall-mounting kit (KX-B063), but rather the one included with
the electronic board (UB-7320).
• When taping the template on the wall, make sure it is level.
3
1) Drill holes in the wall for the wall-mounting fixtures (8 holes total).
• Holes on the wall-mounting fixture are 7 mm (1/4") in diameter.
2) After removing the wall-mounting template, attach the wall-mounting fixtures
with the appropriate wall-mounting hardware (two screws in each fixture).
* This hardware must be locally procured, it is not included in the kit.
• Refer to the section “Attaching the wall-mounting fixtures” (page 40) for drilling in the wall and attaching the
mounting fixtures.
• Refer to step 3 on page 30 for mounting the electronic board.
Caution
Wall-mounting
fixture L
Wall-mounting template
(provided with UB-7320)
Wall-mounting
hardware*
Wall-mounting
hardware*
Wall-mounting
fixture R
812.8 m
m
(
2'
8")
7
6
2
mm (
2
'
6
")
50 mm
(
1
31
/32"
)
70 mm
(2
3
/
4
")
2
1
Wall-mounting
fixture L
1
406.4 mm
(16
")
Center of the
electronic board
(See page 28.)