Filter
Top Products
10 OPERATION
English
Operation
Switch-on/switch-off
Switch the receiver on by pressing the ON/OFF button
(standby button) on the remote control and wait until you
see the welcome image on your screen.
The LED is off if the receiver is switched on.
When you switch on your receiver for the first time, the
LED is blinking while the software is loading. Follow the
steps explained in the section Initial installation on this
page.
When the reciever is in stand-by mode the LED is red.
During a software update process the LED is blinking.
Initial installation
After the first switch-on, you'll receive the following wel-
come window:
1 Press the OK button to proceed to the next page.
2 On the next page, select the desired language by pressing
the arrow button
or , and again press the OK
button.
The settings window is displayed:
Note: Also observe the information messages displayed on the
screen. These will help you to set the correct values. Also with
regard to further operation, information messages are dis-
played.
3 Now successively set the desired values. In doing so,
observe the following:
-By using the arrow buttons
or , you change the
displayed values,
-By using the arrow buttons
or , you switch
between the individual setting possibilities.
4 Then highlight the OK field by using the arrow button
or behind adopt, and press the OK button.
The next window is displayed:
Note: The displayed values for the start and stop frequency
can normally be maintained.
5 If desired, change the values for the start and stop fre-
quency by using the arrow buttons
or.
6 By means of the arrow buttons
or, you define the
channels to be selected: all channels, or channels that
are free-to-air only.
7 Then highlight the OK field by using the arrow button
or next to start scan mode, and press the OK
button.
The scan mode is started. The screen dialog thereby pro-
vides information on the progress of the channel search.
Note: By pressing the EXIT button, you can stop the scan
mode at any time.
As soon as the search is completed, an according message
is displayed. Acknowledge this and the following message
by OK, in order to proceed to the TV replay.
DTR 210 _Phillips.book Seite 10 Mittwoch, 6. September 2006 10:53 10