Filter
Top Products
Setting remote control
code type
When the remote control operation switch is
set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player with the supplied remote control. There
are three remote codes, code type A, code
type B and code type AVH. When operating a
multi-DVD player (e.g. XDV-P650/XDV-P6), se-
lect code A. When operating this unit, select
code AVH.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
! If you select AVH mode, there is no need to
take the following procedure.
! If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Press 0 and CLEAR on the remote con-
trol simultaneously to change the code
type.
Initially, the code type is set to A. Each time
you press 0 and CLEAR simultaneously on the
remote control the code type switches be-
tween A and B.
Setting up the DVD player
En
107
Section
19
Setting up the DVD player