Filter
Top Products
Troubleshooting
Common
Symptom Cause Action (See)
Power doesnt turn on.
The unit doesnt operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that all connections are
correct.
The fuse is blown. Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rating.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
Press RESET.(Page4)
Operation with the remote con-
trol isnt possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
The remote control operation mode
is incorrect.
Switch to the correct remote control mode.
(Page 7)
Battery power is low. Load new battery. (Page 5)
There is no picture. The parking brake cord is not con-
nected.
Connect a parking brake cord, and apply the
parking brake.
The parking brake is not applied. Connect a parking brake cord, and apply the
parking brake.
There is audio and video skip-
ping.
The unit is not firmly secured. Secure the unit firmly.
When the ignition switch is
turned ON (or turned to ACC),
the motor sounds.
The unit is confirming whether a
disc is loaded or not.
This is a normal operation.
Nothing is displayed. The rear view camera is not con-
nected.
B. CAMERA is at incorrect setting.
Connect a rear view camera.
Press V.ADJ to return to the source display
and then select the correct setting for B.
CAMERA. (Page 12)
Additional Information
En
15
English
Appendix