Filter
Top Products
USB PnP(plug andplay)
This settingallows youto switch yoursource toUSB/
USB-iPod automatically.
1 PressM.C. toturn theplug and playon oroff.
ON –When USBstorage device/iPod iscon-
nected, thesource isautomaticallyswitched to
USB/USB-iPod. Ifyou disconnect yourUSB sto-
rage device/iPod, thisunit’s sourceis turnedoff.
OFF –When USBstorage device/iPod iscon-
nected, thesource isnot switchedto USB/USB-
iPod automatically. Pleasechange thesource to
USB/USB-iPod manually.
Illumination (illuminationcolor)
1 PressM.C. todisplay the settingmode.
2 Turn M.C.to selectthe desiredsetting.
Red (red)—Green(green)
3 PressM.C. toconfirm the selection.
Brightness (displaybrightness setting)
1 PressM.C. todisplay the settingmode.
2 Turn M.C.to switchthe brightnesssetting.
High (high)—Low(low)
3 PressM.C. toconfirm the selection.
SW control(rear outputand subwoofersetting)
The rearspeaker leadsoutput (Rear SP)and RCAout-
put (Preout)of thisunit canbe used for full-range
speaker (RearSP:Full/Preout:Rear) orsubwoofer
(Rear SP:SUBW/Preout:SUBW) connection.If you
switch toRear SP:SUBW,you canconnect arear
speaker leaddirectly toa subwoofer withoutusing an
auxiliaryamp.
Initially,Rear SPisset forrear full-rangespeaker con-
nection (Full).When RearSP:Full isselected, youcan
connect theRCA outputto asubwoofer. Inthis case,
you canselect whetherto usethe subwoofer control-
ler’s (lowpass filter, phase)buil t-in Preout:SUBWor
the auxiliary Preout:Rear.
1 PressM.C. todisplay the settingmode.
2 PressM.C. tocycle between asfollowing:
Rear SP/Preout—Full(SUBW)/SUBW(Rear)
3 Turn M.C.to changethe setting.
Rear SP:Full—SUBW
Preout:SUBW—Rear
! Even ifyou changethis setting, thereis no
output unlessyou turnthe subwoofer output
on (referto SWsetting 1(subwooferon/off
setting) onpage 13).
! If youchange thissetting,subwoofer output
in theaudio menuwill returnto the factory
settings.
DEMO (demodisplay setting)
1 PressM.C. tpturn the demodisplay onor off.
Ever SCRL(scroll modesetting)
When EverScroll isset toON, recorded textinforma-
tion scrollscontinuously inthe display.Set toOFF if
you preferthe informationto scroll justonce.
1 PressM.C. toturn theever scroll onor off.
Other Functions
Using the AUX source
1 Insert the stereomini plug into the
AUX input jack.
2 Press SRC/OFF to select AUX as the
source.
Note
AUX cannot be selected unlessthe auxiliary set-
ting is turned on. For more details, refer to AUX
(auxiliary input) on the previous page.
Turning the clock display on or
off
% Press CLK to turn the clock display on
or off.
Note
The clock display disappears temporarilywhen
you perform other operations, but the clock dis-
play appears again after 25 seconds.
Operating this unit
En
15
English
Section
02