Pioneer DEH-P610BT Car Stereo System User Manual


 
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Press SRC/OFF and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
LANGUAGE (language selection)
CALENDAR (calendar)CLOCK (clock)
WARNING (warning tone)AUX1 (auxiliary
input 1)AUX2 (auxiliary input 2)REAR SP
(rear output and subwoofer output)AMP
(power amp setting)EVERSCROLL (ever
scroll)BTAUDIO (Bluetooth audio)
BT MEMORY CLR (clearing Bluetooth mem-
or y)S/W UPDATE (software update)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND/ESC.
Selecting the language
For your convenience, this unit equips multi-
ple language display. You can select the lan-
guage best suited to your first language.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select
LANGUAGE in the initial setting menu.
3 Push MULTI-CONTROL left or right to
select the language.
ENG (English)ESPAÑOL (Spanish)
4 Press MULTI-CONTROL to determine
the selection.
Setting the date
The calendar display adjusted in this mode ap-
pears when the telephone source is selected
or sources and the feature demo are off.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select
CALENDAR in the initial setting menu.
3 Push MULTI-CONTROL left or right to
select the segment of the calendar display
you wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the calendar display:
DayMonth
As you select segments of the calendar dis-
play the segment selected will blink.
4 Push MULTI-CONTROL up or down to
set the date.
Pushing MULTI-CONTROL up will increase
the selected day or month. Pushing
MULTI-CONTROL down will decrease the se-
lected day or month.
Setting the clock
Use these instructions to set the clock.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select CLOCK in
the initial setting menu.
3 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the clock display:
HourMinute
As you select segments of the clock display,
the selected segment blinks.
# You can match the clock to a time signal by
pressing MULTI-CONTROL.
Initial Settings
En
42
Section
10