Filter
Top Products
16 Installation
Installation
3
Assemble the
speakers
Speaker Setup for HTZ-BD50
Preparing the speakers
1. Attach the non-skid pads to the base of
each speaker stand bases, the subwoofer
and the center speaker.
For speaker stand bases:
Use the supplied adhesive to attach four
middle pads to the base (bottom) of each
speaker stand base.
middle non-skid pads
For subwoofer:
Use the supplied adhesive to attach four
large pads to the base of subwoofer.
large non-skid pads
For center speaker:
Use the supplied adhesive to attach four
small pads to the base of center speaker.
small non-skid pads
2. Attach the speaker stand bases to the stems
using the screws provided.
Once you have aligned the stem and base,
secure with the small screws at the points
shown below. Note that the speaker should
face in the direction of the base of the
isosceles triangle.
Rear
Front
3
Installation
HB985-FB.BUSAPPK_Eng.indd 16HB985-FB.BUSAPPK_Eng.indd 16 2010-05-14 10:47:482010-05-14 10:47:48