Pioneer HTZ-BD50 Car Stereo System User Manual


 
58
Operation
Operation
4
Radio Operations
Be sure that the antenna is connected.
(Refer to the page 24)
Listening to the radio
1. Press INPUT/TUNER until TUNER (FM)
appears in the display window. The last
received station is tuned in.
2. Press and hold TUNE (-/+) for about two
seconds until the frequency indication
starts to change. Scanning stops when the
unit tunes in a station. Or Press TUNE (-/+)
repeatedly.
3. Adjust the volume by rotating VOLUME on
the front panel or by pressing VOL (+/- ) on
the remote control.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure that you have turned
down the volume.
1. Press INPUT/TUNER until the TUNER (FM)
appears in the display window.
2. Select the desired frequency by using TUNE
(-/+).
3. Press ENTER (
) a preset number will  ash
in the display window.
4. Press PRESET to select the preset number
you want.
5. Press ENTER (
). The station is stored.
6. Repeat the steps 2 to 5 to store other
stations.
Deleting all the saved stations
Press and hold CLEAR for two seconds.
“ERASE ALL” will  ash up. Press CLEAR again.
Then all the saved stations are deleted.
Improving poor FM reception
Press D (blue) (ST/ MONO) colored button on
the remote control. This will change the tuner
from stereo to mono and usually improve the
reception.
HB985-FB.BUSAPPK_Eng.indd 58HB985-FB.BUSAPPK_Eng.indd 58 2010-05-14  10:47:582010-05-14  10:47:58