Filter
Top Products
10. When Auto-equalizing is completed, a message is displayed as below.
When correct measurement of car interior acoustic characteristics is not possible, an error
message is displayed. (Refer to error messages on this page.)
11. To cancel the Auto-equalizing mode, press any button.
12. Store the microphone carefully in the glove compartment.
Store the microphone carefully in the glove compartment or other safe place. If the micro-
phone is subjected to direct sunlight for an extended period, high temperatures may cause
it to deform, change color and malfunction.
7 When Auto-equalizing was performed correctly:
AUTO EQ ON applies to, and the “AUTO EQ” indicator lights for, all equalizer curves
that are called (refer to page 39.). The called equalizer curve is set after it is corrected by
Auto-equalizing.
Error Cords of Auto-equalizing Function
When correct measurement of car interior acoustic characteristics is not possible with the
Auto-equalizer, the following error messages are displayed. After checking, try again.
Display Cause Remedy
ERROR-1 Microphone is not connected. Plug in the supplied microphone
securely into the jack.
ERROR-2 The microphone cannot pick up Confirm that the speakers are
the measuring tone of the front connected correctly.
and rear speakers.
Set the input level setting of the power
amp connected to the speakers
correctly.
Correctly set the microphone.
ERROR-3 The surrounding noise level is too Stop your car in a place that’s as quite
high. as possible, and switch off the engine
and air conditioner or heater.
Correctly set the microphone.
“AUTO EQ”
44
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS