Filter
Top Products
48
Connecting the amplifier/mixing console
The two audio outputs of the twin receiver are available as transformer
balanced XLR-3M sockets. You can connect an amplifier or a mixing console
to each audio output.
̈ Connect the amplifier/mixing console to the XLR-3M sockets AF OUT B ƻ
(receiver RX B) or AF OUT A Ƽ (receiver RX A).
̈ Via the operating menu, adapt the level of the audio output (AF OUT A
and/or AF OUT B) to the input of the amplifier/mixing console (see
“Adjusting the audio output level” on page 58).
Service interfaces
The two service interfaces DATA B ƹ and DATA A ƺ are only required for
servicing purposes.
Mounting the twin receiver into a 19” rack
For mounting the twin receiver into a 19” rack, use the supplied GA 2 rack
adapter. The GA 2 rack adapter consists of:
y 2 rack mount “ears” ƾ
y 4 recessed head screws M 3x6
̈ Hook the two rack mount “ears” ƾ to the rear panel of the twin receiver.
̈ Secure the rack mount “ears” to the twin receiver using two of the
supplied recessed head screws (M 3x6) respectively.
̈ Slide the twin receiver into the 19” rack.
̈ Secure the rack mount “ears” to the rack.
Mounting the antennas
When rack-mounting the twin receiver, use the GA 3030 AM antenna mount
(optional accessory) for mounting the telescopic antennas to the front of the
GA 2 rack adapter. The GA 3030 AM antenna mount consists of:
y 2 BNC extension cables (screw-in BNC socket ƿ to BNC connector )
y 2 antenna holders
y 2 plain washers
y 2 nuts
ƻ Ƽ
ƹ ƺ
ƾ
ƾ
ƿ
EM_550_G2.book Seite 48 Donnerstag, 27. November 2003 1:33 13