Filter
Top Products
50
Using the twin receiver
Switching the twin receiver on/off
Each receiver of the EM 550 G2 is switched on and off separately with the ON
button. The receivers can only be switched off when the standard display is
shown on the display panel. When in the operating menu, briefly pressing the
ON button will cancel your entry (ESC function) and return you to the
standard display with the last stored settings.
̈ Press the ON button ² to switch the receiver on.
̈ To switch the receiver off, press the ON button until “OFF” appears on the
display.
Connecting the headphones/adjusting the volume
Each receiver of the EM 550 G2 has its own separate headphone output ᕡ for
monitoring the audio signal.
̈ Connect headphones with a ¼” (6.3 mm) jack plug to the headphone
output (PHONES) ᕡ.
Attention! High volume!
Even short exposure to high volume levels will damage your hearing!
Set the volume for the connected headphones to the minimum before
putting the headphones on.
̈ First, set the volume control ᕢ to the lowest volume by turning it to the
left as far as possible. Then gradually turn up the volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.
Activating/deactivating the lock mode
Each receiver of the EM 550 G2 has a lock mode that can be activated or
deactivated via the operating menu (see “Activating/deactivating the lock
mode” on page 61). The lock mode prevents that the receiver is accidentally
programmed or switched off during operation.
²
³ ·
EM_550_G2.book Seite 50 Donnerstag, 27. November 2003 1:33 13