Filter
Top Products
19
HT-DV40H
HT-DV50H
Preparation for Use
Subwoofer
Caution:
Aerial connection
External FM aerial
Use an external FM aerial if you require better reception.
Consult your dealer.
Note:
When an external FM aerial is used, disconnect the supplied FM
aerial wire.
AC power connection
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket. If you plug in the
unit first, the unit will enter the stand-by mode.
Note:
Unplug the AC power lead from the wall socket if the unit will not be
in use for a prolonged period of time.
Demonstration mode
1 Connect the wire without insulation tube to the SUBWOOFER
minus (
-
) terminal, and the wire with purple insulation tube to
the SUBWOOFER plus (+) terminal.
Never mistake the FRONT SPEAKERS and the SUBWOOFER
terminals. The unit or the speakers may be damaged.
If you use other speakers with an impedance lower than that
specified, the unit may be damaged. Front speakers: 4 ohms,
Subwoofer: 12 ohms.
Do not mistake the right and the left
channels. The right speaker is the one on
the right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex duct.
Do not stand or sit on the subwoofer/
speakers. You may be injured.
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS
socket and position the FM aerial wire in the
direction where the strongest signal can be
received.
Note:
Placing the aerial on the unit or near the AC
power lead may cause noise pickup.
Place the aerial away from the unit for better
reception.
Purple
Incorrect
FM
aerial
The first time the unit is plugged in, the unit
will enter the demonstration mode. You will
see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode
(demonstration mode), press the SHIFT and
DEMO buttons on the remote control. The unit
will enter the low power consumption mode.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the SHIFT and
DEMO buttons on the remote control again.
75 ohms
coaxial cable
External
FM aerial
Wall socket
(AC 220 - 240 V ~ 50 Hz)