Filter
Top Products
53
HT-DV40H
HT-DV50H
Radio Operation
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING ( or ) button again.
When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator will
light up. Finally, the station name will appear.
Full auto tuning can be achieved for RDS stations “ASPM”, see
page 55.
To receive an FM stereo transmission:
Press the TUNER button to select stereo mode and “ST” indicator
will be displayed.
“ ” will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER button to extinguish
the “ST” indicator. The reception changes to monaural, and the
sound becomes clearer.
Memorising a station
Up to 30 stations for FM band can be stored and recalled at the push
of a button. (PRESET
( or ) )
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead become
disconnected.
To recall a memorised station
Press the PRESET ( or ) button for less than 0.5 seconds
to select the desired station.
To scan the preset stations
The station saved in memory can be scanned automatically. (Preset
memory scan)
To erase entire preset memory
FM stereo receiving indicator
FM stereo mode indicator
1 Perform steps 1 - 3 in “Tuning” on page 52.
2 Press the MEMORY/DIMMER button to enter the preset
tuning saving mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY/DIMMER button to
store that station in memory.
If the “MEMORY” and preset number indicators disappear
before the station is memorised, repeat the operation from step
2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.
1
Press the PRESET ( or ) button for more than 0.5
seconds. The preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Press and hold CLEAR/DISPLAY button until "TUNER CLEAR"
appears.