Filter
Top Products
9
Quick guide
Initial auto installation
When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings one
after another.
Confirm the following before turning on
the power
Is the antenna cable connected?
Is the AC cord plugged in?
E
E
Press a on the TV.
The initial auto installation wizard appears.
Setting the OSD language.
Português
English
Press a/b to select the desired language, and
then press ;.
Selecting the location of the TV.
STORE
HOME
Press a/b to select where you will use this TV,
and then press ;.
HOME: “STANDARD” will be the default value for the “AV
MODE” setting.
STORE: “DYNAMIC (Fixed)” will be the default value for
the “AV MODE” setting. If the “AV MODE” is changed,
the TV will automatically switch back to “DYNAMIC
(Fixed)” when there is no signal input from the TV or
remote control unit for 30 minutes.
Setting the country.
Finland
Austria
Press a/b to select your country or area, and
then press ;.
This setting screen only appears during the first
installation.
1
•
2
3
•
•
4
•
Starting channel search.
Skip
Start
Press a/b to select “Start” or “Skip”, and then
press ;.
If you want to search for more broadcasts, execute
“Additional Search” from the “Programme Setup” menu
(Page 21).
The TV searches for, sorts and stores all
the receivable TV stations according to
their settings and the connected antenna.
To abort the initial auto installation in progress, press
RETURN.
NOTE
If you turn off the power on the TV after performing step 5 or
if you select “Skip” on step 5, the initial auto installation wizard
will not appear. The auto installation function allows you to
execute the installation again from the “Setup” menu (Page 20).
The initial auto installation wizard will go off if you leave the TV
unattended for 10 minutes before searching for channels in
step 6.
After initial auto installation is completed, the default PIN is
automatically set to “1234”. To change the PIN setting, refer to
Password/Parental lock settings (Page 22). To clear the PIN
setting (PIN input will no longer be needed), refer to CLEARING
THE PIN (Page 24).
When “Italy” is selected in the country setting, the default PIN is
automatically set to “1234” and the default age restriction value
is set to 18.
Checking signal strength
If you install an antenna for the first time or relocate it, you
should adjust the alignment of the antenna to receive a
good reception while checking the antenna setup screen.
Press @ and the “MENU” screen
displays.
Press c/d to select “Setup”.
Press a/b to select “Antenna Setup”, and
then press ;.
Press a/b to select “Signal Strength”.
NOTE
The values of “Signal Strength” indicates when to check the
appropriate alignment of the antenna.
5
•
6
•
•
•
•
•
1
2
3
4
•