Filter
Top Products
10
Watching TV
Daily operation
Switching on/off
Turning on/off the power
Press a on the TV.
Switch it off by pressing a on the TV.
Standby mode
To standby mode
If the TV is switched on, you can switch it to standby by
pressing B on the remote control unit.
Switching on from standby
From standby, press B on the remote control unit.
TV indicator status
B (Standby/On
indicator)
Status
Off
Power off
Green
Power on
Red
Standby
NOTE
If you are not going to use this TV for a long period of time, be
sure to remove the AC cord from the AC outlet.
A small amount of electric power is still consumed even when
a is turned off.
Switching between digital and
analogue broadcasts
Watching digital
broadcasts
Watching analogue
broadcasts
001 to 900 ch From 901 ch
NOTE
If the TV cannot search digital broadcasts, the analogue
broadcasts are set from 001 channel.
Changing channels
With :r/s: With 0_9:
E
E
•
•
•
Selecting an external video
source
Once the connection is made,
press b to display the “INPUT
SOURCE” screen, and then press
b or a/b to switch over to
the appropriate external source
with ;.
INPUT SOURCE
TV
EXT1
EXT2
EXT3
Selecting a sound mode
For DTV
If multi sound modes are received, each time you press
; the mode switches as follows.
Audio (ENG) : STEREO
L/R LRLR
Audio (ENG) : CH A
Audio (ENG) : CH B
Audio (ENG) : MONO
Press c/d to select L or R sound when the STEREO or
DUAL MONO screen is displayed.
Audio (ENG) : STEREO
L/R LRLR
NOTE
The sound mode screen disappears in six seconds.
Selectable items vary depending on the received broadcasts.
For ATV
Each time you press ;, the mode switches as
shown in the following tables.
NICAM TV broadcasts selection
Signal Selectable items
Stereo
NICAM STEREO, MONO
Bilingual
NICAM CH A, NICAM CH B, NICAM CH AB, MONO
Monaural
NICAM MONO, MONO
A2 TV broadcasts selection
Signal Selectable items
Stereo
STEREO, MONO
Bilingual
CH A, CH B, CH AB
Monaural
MONO
NOTE
When no signal is input, the sound mode will display “MONO”.
E
•
•
E
•