Filter
Top Products
30
E
Specications
n
Dimensional Drawings
Note that the values shown are approximate values.
30-1/4 [769]
Opening width (
27-5/8
[701])
18-13/16 [478]
Opening height (15-9/16 [396])
18-1/8 [461]
7-7/8 [200]
1-1/2
[38]
7-7/8 [200]
VESA holes *
Unit: inch [mm]
2-7/16
[62]
When mounting the monitor, be sure to use a wall-mount bracket that complies with the VESA-compatible mounting method.
SHARP recommends using M6 screws and tighten the screws.
Note that screw hole depth of the monitor is 3/8 inch (10 mm). Loose mounting may cause the product to fall, resulting in
serious personal injuries as well as damage to the product. The screw and hole should come together with over 5/16 inch
(8 mm) length of thread. Use a bracket which has been approved for UL1678 standard, and which can endure at least 4 times
or more the weight of the monitor.
n
Power management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support the same standard in
order for the monitor’s power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen
Power
consumption
Hsync Vsync
ON STATE Display 82 W Yes Yes
STANDBY
No
display
0.9 W
No Yes
SUSPEND Yes No
OFF STATE No No
DMPM: Digital Monitor Power Management
DMPM Screen
Power
consumption
Monitor ON Display 82 W
Active OFF No display 10 W
n
DDC (plug and play)
The monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for plug and play between monitors and computers. Information about resolution and other parameters
is exchanged between the two. This function can be used if the computer supports DDC and it has been congured to detect
plug-and-play monitors.
There are several types of DDC, depending on the communication method used. This monitor supports DDC2B.