Filter
Top Products
24
Options 1 & 2: Aux In Cable Or Cassette Adapter Installation Instructions
1 Plug one end of the Aux In Cable (or Cassette Adapter)
into the AUDIO connector on the Base of Snap.
2 Plug the other end into the auxiliary input jack of your
vehicle’s stereo system (or insert the Cassette Adapter
into the cassette deck; you may need to turn on the
stereo system first).
3 Turn on your vehicle’s stereo system. Set it to play from
the auxiliary input source (or cassette source if using
a Cassette Adapter). You should hear XM channel 1
through your vehicle’s stereo system. The installation is
complete. Proceed to “Step 5: Tune to Other Channels,
Explore and Enjoy” on page 27.
4 The audio level output of Snap
can be increased or
decreased as necessary to match the audio levels of other
sources in your vehicle. Refer to “Set Audio Level” on
page 39.
If the signal reception is good, showing at least one bar in the upper left corner of the display, but
there is no XM audio, be sure the vehicle’s stereo system is set to the correct source (step 3). Also
be sure that the audio level is set high enough to be heard (step 4). Refer to “Troubleshooting” on
page 42 for additional help.
AUDIO FM
Audio
Connector
Aux In Cable
Aux In
Optional Cassette
Adapter
Installation and Setup