Filter
Top Products
24
DSR Series
20
..
..
.4B : DMC RUN
This command is used to let the DEVICE perform a series of operations in the VAR MEMORY
mode.
1. Cues up the tape to the following point.
Point IN _ (set first speed x PREROLL TIME)
2. Runs at the set first speed to the point IN.
3. Stores the speed that is given by the PLAY, VAR FWD and VAR REV from the point IN.
20
..
..
.4C : DMC PREVIEW
This command is used so that the DEVICE performs the following serial operations in the VAR
MEMORY mode.
1. Cues up the tape to the following point.
Point IN _ (stored first speed x PREROLL TIME)
2. Runs at the stored first speed to the point IN.
3. Reproduce the tape speed that is stored in the point IN.
20.52 : TENSION RELEASE
When receiving the above command in STILL mode of STOP or SHUTTLE/JOG/VAR, the
DEVICE will be in the TENSION RELEASE mode.
20.54 : ANTI-CLOG TIMER DISABLE
20.55 : ANTI-CLOG TIMER ENABLE
“20.54 : ANTI-CLOG TIMER DISABLE” prohibits the operation of the ANTI-CLOG TIMER.
“20.55 : ANTI-CLOG TIMER ENABLE” permitted the operation of the ANTI-CLOG TIMER.
When turning on the power, ANTI-CLOG TIMER ENABLE mode is in the enable mode.
2X.5C : DMC SET FWD
2X.5D : DMC SET REV
This command is used to preset the DEVICE as the set value of the first speed of “20.4B : DMC
RUN” command during the VAR MEMORY mode.
The set value is specified in the DATA-1 of the following command. For the data format, refer
to “2X.11 : JOG FWD”.
20
..
..
.60 : FULL EE OFF
20
..
..
.61 : FULL EE ON
These commands are used to set or clear all channels to EE mode.
When receiving this command, the DEVICE will start executing after passing the edit delay
(three frames) time.
For the timing, refer to APPENDIX-1.
20.63 : SELECT EE ON
This command is used to set each EDIT PRESET channel assigned by the DATA-1 of the
“41.30 : EDIT PRESET” command to the EE mode.
To clear the SELECT E-E mode, the “20.64 : EDIT OFF” command is used.
When receiving this command, the DEVICE will start executing after passing the edit delay
(three frames) time.
For the timing, refer to APPENDIX-1.
20.64 : EDIT OFF
This command is used to clear the EDIT mode and also clear the SELECT EE mode.
When receiving this command, the DEVICE will start executing after passing the edit delay
(three frames) time.
For the timing, refer to APPENDIX-1.