Filter
Top Products
TASCAM US-16x08
5
2 – Names and functions of parts
Rear panel
9 USB port
Use the included USB cable to connect the unit to a
computer or iOS device (supports USB 2.0).
CAUTION
•
USB 1.1 is not supported.
•
When connected to a USB 3.0 port, it will function in High
Speed mode equivalent to USB 2.0 (480 Mbps maximum).
0 MIDI OUT connector
This 5-pin DIN is a standard MIDI output connector.
This outputs MIDI signals.
q MIDI IN connector
This 5-pin DIN is a standard MIDI input connector.
Use this to input MIDI signals.
w LINE IN 11-16 (balanced) jacks and switches
These are standard TRS line input jacks. Use the LEVEL
switches to set the nominal level to −10 dBV or +4 dBu.
(Tip: HOT, Ring: COLD, Sleeve: GND)
NOTE
The input gain cannot be adjusted for these jacks.
e Cord holder
Attach the cord of the included AC adapter here to prevent
the plug from becoming disconnected.
r LINE OUT 1-8 (balanced) jacks
These are standard TRS analog line output jacks. Their
nominal output levels are +4 dBu.
(Tip: HOT, Ring: COLD, Sleeve: GND)
t AUTO POWER SAVE switch
This can be set to have the unit turn itself off (start standby)
automatically if no input signal (above −60 dBFS) has been
detected for 30 minutes when operating in mic preamp
mode.
CAUTION
If you want to turn the unit on again after it has turned itself
off (entered standby) automatically using this function, set
the STANDBY/ON switch to STANDBY once, wait at least 8
seconds and then set it to ON again.
y DC IN 12V connector
Connect the included AC adapter (GPE248-120200-Z) here.