Filter
Top Products
66
Getting Started
Installing additional memory (optional)
5.375 x 8.375 ver 2.3
You need a standard Phillips no. 1 screwdriver to install a
memory module.
To avoid damaging the computer’s screws, use a standard
Phillips no. 1 screwdriver that is in good condition.
If you are adding memory after you have started to use the
computer, begin at step 1, otherwise skip to step 2.
1 Turn off the computer via the Start menu.
See “Turn Off or Shut down command” on page 95.
The operating system turns off the computer.
2 Unplug and remove any cables connected to the
computer.
3 Close the display panel and turn the computer upside
down to locate the memory slot cover.
Base of your Satellite computer
4 Using a standard Phillips no. 1 screwdriver, unscrew the
screw that secures the memory slot cover, then remove
the memory slot cover.
Memory
slot cover