ViewSonic CD4620 55
6.3 Remote Control Pass-through mode
When PC sets the LCD monitor to Remote Control Pass through mode, the LCD shall send a three
bytes packet (followed by “CR”) in response to RCU button activation. Note, that in this mode the RCU
shall have no effect on the monitor function. For example: “+Volume” will not change the volume in the
LCD but only sends “+Volume” code to PC over the RS232 port.
Remote Control pass-through packet format from LCD monitor to PC(ASCII)
Name
Length RCU-Code1 RCU-Code2 CR
Byte Count
3 MSB LSB 00D
Bytes order 1 2 3 4
Example: Remote Control pass-through when “Menu” key is pressed (1A)
Name
Length RCU-Code1 RCU-Code2 CR
Byte Count
3 1 A 00D
Bytes order 1 2 3 4
Example: Remote Control pass-through when key “1” is pressed (01)
Name
Length RCU-Code1 RCU-Code2 CR
Byte Count
3 0 1 00D
Bytes order 1 2 3 4
Example: Remote Control pass-through when “OK” key is pressed (1F)
Name
Length RCU-Code1 RCU-Code2 CR
Byte Count
3 1 F 00D
Bytes order 1 2 3 4
Key Code (HEX)
Size 0F
Volume Up (+) 10
Volume Down (-) 11
Mute 12
POWER 15
INPUT 16
PIP ON/OFF 17
MENU 1A
Up 1B
Down 1C
Left(-) 1D
Right(+) 1E
SET 1F
PIP INPUT 00
PIP CHANGE 00
PICTURE MODE 00
AUDIO INPUT 00
SCREEN SAVER GAMMA 00
SCREEN SAVER BRIGHTNESS 00
DISPLAY 00
AUTO SETUP 00
EXIT 00
Downloaded From TV-Manual.com Manuals