Filter
Top Products
VIZIO VSB200 User Manual
8
www.VIZIO.com
Top
TopTop
Top Panel
Panel Panel
Panel Buttons
ButtonsButtons
Buttons
1. Power – Use this button to turn HD Sound Bar ON or OFF.
2. Input – Use this button to select the input desired. Repeated pressing will cycle through Analog
Input 1, Analog Input 2 or Optical In.
3. Vol - – Pressing this button will decrease the volume level.
4. Vol+ – Pressing this button will increase the volume level.
5. Mute – Pressing this button will either mute or un-mute the Sound Bar.
6. TVOL– Pressing this button will set the sound system to have control over the level of the audio
output, preventing commercials on regular programming to become louder than the volume of
the program being viewed. Pressing this button will toggle SRS TruVolume ON and OFF
7. TSHD – Pressing this button will toggle SRS TruSurroundHD ON and OFF.
Front LED Array
Front LED ArrayFront LED Array
Front LED Array
The LED Array is located at the lower right side of the Sound Bar.
There are a total of 10 LEDs. The first white LED is the Power indicator. The next 6 white LEDs are
volume indicators. Each LED has three brightness levels for a total of 18 volume settings.
Displayed as a bar graph representing the system volume, increasing from the left across the
display. The display is constantly on when active.
LED 2, 4 and 6 (from left) function as Input indicators. When the Input button is pressed, these three
LED’s light up, with the status of the currently selected input LED flashing. The LED’s will turn off
after 5 seconds. Pressing the Input button on the top of the Sound Bar or the remote will step
through the inputs. LED 2 is Analog Input 1, LED 4 is Analog Input 2 and LED 6 is Optical Input.
The next LED is for SRS TruVolume. Glows blue when on.
The last LED is for SRS TSHD. Glows blue when on.
After an adjustment or change in SRS settings is made, the LED’s turn off after 5 seconds. Press any
button on the remote and the LEDs turn on to show status.
When the bar is muted, the volume LEDs blink at the current volume setting.
REMOTE CONTROL SENSOR – The Remote Sensor is located at the lower right side of the Sound Bar.
This is the window through which all of the remote control signals pass to the sensor. Point the remote
control directly at this window for the best response to the remote signal.