Filter
Top Products
P-660H-Tx v2 Support Notes
The P-660H-Tx v2 has 8 remote nodes and so allows you to configure 8 NAT
Address Mapping Sets, You must specify which NAT Address Mapping Set
(1~8) to use in the remote node when you select Full Feature NAT.
You can edit 10 rules for each Address Mapping Set. You can edit the rules for
Address Mapping Sets #1 in Web Configurator. The other Address Mapping
Sets #2~8 can only be configured in CLI (Command Line Interface).
The NAT Server Set is a list of LAN side servers mapped to external ports. We
can configure it in Web Configurator, Advanced Setup, Network -> NAT ->
Port Forwarding. To use the NAT server sets you’ve configured, a Server
rule must be set up inside the NAT Address Mapping set. Please see NAT
Server Sets for further information on how to apply it.
When you select SUA Only, the P-660H-Tx v2 will use a default SUA Address
Mapping set for it. It has two rules: Many-to-One and Server. You can see it in
CLI by command ‘ip nat lookup 255’:
Please note that the fields in this menu are read-only. However, the settings of
the rule set 2 can be modified in Web Configurator, Advanced Setup, Network
-> NAT -> Port Forwarding. The following table explains the fields in this
above screen:
Field Description Option/Example
set This is sequence number for Address Mapping Sets 255 for SUA
Internal
Start IP
This is the starting local IP address (ILA).
0.0.0.0 for the
Many-to-One type.
Local End
IP
This is the starting local IP address (ILA). If the rule is
for all local IPs, then the Start IP is 0.0.0.0 and the
End IP is 255.255.255.255.
255.255.255.255
Global Start
IP
This is the starting global IP address (IGA). If you
have a dynamic IP, enter 0.0.0.0 as the Global Start
0.0.0.0
42
All contents copyright © 2006 ZyXEL Communications Corporation.