Chapter 6. Hotkey Operation
121
Hotkey Beeper Control
The beeper (see SET BEEPER, page 103) can be toggled on and off by means
of a hotkey. To toggle the beeper, enter the following hotkey combination:
1. Invoke Hotkey mode (see page 117).
2. Press [B]
After you press B, the beeper toggles on or off. The command line displays
BEEPER ON or BEEPER OFF for one second; then the message disappears
and you automatically exit Hotkey mode.
Hotkey Summary Table
* The user’s Scan Mode settings and port access rights determine which ports
are available in Auto Scan mode. To change Scan Mode settings,
see SET SCAN, page 101.
[Num Lock] + [-]
-or-
[Num Lock] + [*]
[port ID] [Enter] Switches access to the KVM port that
corresponds to that port ID.
[T] [n] [Enter] Sets the Auto Scan mode interval to n
seconds—where n is a number from
1–240.
[A] Invokes Auto Scan mode.
When Auto Scan mode is in effect, press
[P] or left-click to pause Auto Scan mode.
When Auto Scan mode is paused, press
any key or left-click to resume Auto Scan
mode.
Press [Esc] or [Spacebar] to exit Auto
Scan mode.
[←] In Auto Scan mode, skips to the previous
port in the OSD list.*
[→] In Auto Scan mode, skips to the next port
in the OSD list.*
[↑] In Auto Scan mode, skips to the first port
in the OSD list.*
[↓] In Auto Scan mode, skips to the last port
in the OSD list.*
[B] Toggles the beeper on or off.
