PN9108 User Manual
74
Method 3:
A fixed IP address can also be assigned with the ARP command as follows:
1. Turn off the power to the PN9108.
2. Enter the following command:
arp -s <ip address> <PN9108's MAC address>
Where the IP address that you assign is one suitable for the network
segment that the PN9108 resides on.
Note: The PN9108's MAC address can be found on its bottom panel.
3. Turn the power to the PN9108 back on.
4. In your browser, go to the IP address you just assigned and log in with
your Username and Password.
Note: You must log in within 30 seconds after entering the arp command.
Therefore, it would be advisable to have your browser all set up to
go to the IP address beforehand.
5. Once you have logged in, go to Network Settings to set up the permanent
IP environment (see page 21).
pn9108.book Page 74 Friday, December 14, 2007 4:38 PM
