A SERVICE OF

logo

Open as PDF
next previous
PN9108 User Manual
82
Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted, or you have forgotten it, for
example), you can clear the login information with the following procedure:
1. Power off the PN9108 and remove its housing.
2. Short the jumper labeled J6.
3. Power on the switch.
4. When the Link and 10/100Mbps LEDs flash, power off the switch.
5. Remove the jumper cap from J6.
6. Close the housing and start the PN9108 back up.
After you start back up, you can use the default Username and Password
(see page 13) to log in.
pn9108.book Page 82 Friday, December 14, 2007 4:38 PM