RGTNB 2008
SITE PREPARATION
• This appliance has been designed to be in-
stalled directly against rear walls and side
base cabinets. It cannot be installed di-
rectly against tall side cabinets, side walls,
tall appliances or base cabinets extending
beyond 24 inches [610 mm].
• Side trims must be at least 11/16 inch [17.5
mm] above the adjoining counter top sur-
faces.
• Any openings in the back wall or the floor
of the installation site must be sealed.
• Each gas appliance shall be located with
respect to building construction and other
equipment to permit access to the appli-
ance. Such access and clearance is neces-
sary for cleaning and servicing.
• Do not push against the edges or sides of
any appliance in an attempt to slide it into
position. Although all metal parts are de-
burred during the manufacturing process,
serious injury could occur if the appliance
were to move suddenly while being posi-
tioned. We recommend you use gloves
during the installation process.
• For optimum performance the appliance
should be leveled during installation. A
carpenter type level should be placed on the
unit three ways: side to side; front to back;
diagonally.
•
If the appliance is installed in an island or
cabinet cut-out the edges should be
shimmed with small metal coupons
