Port Aggregator Commands 567
minimum active uplinks
Use the minimum active uplinks command to set the minimum number of
uplinks to be active for the Group. For example, if the number of uplink ports
in the group is 2 and the number of internal ports is 4. If the user sets the
minimum active uplink ports to be 2, then both the uplink ports should be
active; otherwise, all the internal ports in the Group will be brought down. By
default, the minimum active uplinks for a Group is 1, which means at least
one uplink port should be active for the Aggregator Group to be active.
Syntax
minimum active uplinks
<number of uplinks>
•
number of uplinks
— Minimum number of uplinks to be active for the
Aggregator Group to be active. (Range: 1-4)
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#minimum active uplinks 2
console(config-aggregator-2)#
mtu disable
Use the mtu disable command to set the mtu size to default (1518) on all the
member ports in the aggregator group/zone. To set the mtu size to the
maximum value (9216), use the no form of this command.
2CSPC4.XModular-SWUM200.book Page 567 Thursday, March 10, 2011 11:18 AM
