RADIUS Commands 665
radius-server source-ip
Use the radius-server source-ip command in Global Configuration mode to
specify the source IP address used for communication with Radius servers. To
return to the default, use the no form of this command. 0.0.0.0 is interpreted
as a request to use the IP address of the outgoing IP interface.
Syntax
radius-server source-ip
source
no radius-server source-ip
•
source
— Specifies the source IP address.
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the source IP address used for
communication with Radius servers to 10.1.1.1.
console(config)#radius-server source-ip 10.1.1.1
radius-server timeout
Use the radius-server timeout command in Global Configuration mode to set
the interval for which a switch waits for a server host to reply. To restore the
default, use the no form of this command.
Syntax
radius-server timeout
timeout
no radius-server timeout
2CSPC4.XModular-SWUM200.book Page 665 Thursday, March 10, 2011 11:18 AM
