Port Channel Commands 583
Example
The following example configures the priority value for port 1/0/8 to 247.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp port-priority 247
lacp static
Use the lacp static command to set the LACP (Link Aggregation) mode to
static for that Aggregator Group. This means that when more than one uplink
port is in the Group, those uplink ports will be enabled automatically with
static LACP.
Syntax
lacp static
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#lacp static
console(config-aggregator-2)#
lacp system-priority
Use the lacp system-priority command in Global Configuration mode to
configure the Link Aggregation system priority. To reset to default, use the no
form of this command.
2CSPC4.XModular-SWUM200.book Page 583 Thursday, March 10, 2011 11:18 AM
