IPv6 Routing Commands 973
User Guidelines
This command has no user guidelines.
Example
The following example sets at 10 the number of duplicate address detection
probes transmitted while doing neighbor discovery.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd dad attempts 10
ipv6 nd managed-config-flag
Use the ipv6 nd managed-config-flag command in Interface Configuration
mode to set the “managed address configuration” flag in router
advertisements. When the value is true,
end nodes use DHCPv6. When the value is false, end nodes automatically
configure addresses.
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
In the following example, the end node uses DHCPv6.
console(config)#interface vlan 15
2CSPC4.XModular-SWUM200.book Page 973 Thursday, March 10, 2011 11:18 AM
