MOTOR AND MOTOR MOUNTING
PLATE TO SAW
1. Insert the tapered end of pin (G) Fig. 32, into the
inside holes in each side of bracket (H).
3. Assemble spring (I) Fig. 32, onto the non-tapered
end of each pin (G) as shown.
4. Position motor and motor mounting plate (A) Fig. 33,
below bracket (B) to allow bracket arm to slide through
large opening (C) in motor mounting plate (A).
5. Depress pins, one of which is shown at (D) Fig. 33,
on both sides of bracket (B) and lift up motor mounting
plate (A) until pins (D) are engaged in holes (E) Fig. 33, of
motor mounting plate (A).
6. Fig. 34, illustrates the motor and motor mounting
plate assembled to the rear of the saw.
G
Fig. 32
H
I
G
G
Fig. 33
A
B
C
Fig. 34
D
E
MOTOR PULLEY, PULLEY GUARD,
AND DRIVE BELT
1. Remove the motor shaft key (No. 14, Fig. 4) that is
taped to the motor.
2. Insert key (F) Fig. 35, in the keyway on the motor
shaft. Assemble motor pulley (G) on motor shaft as
shown, with the hub of the pulley out. Tighten set
screw (H) against key (F) in motor shaft.
Fig. 35
15
F
G
H
