ON/OFF SWITCH
Insert a 3/8-16x 1½" Flat Head Screw (F) Fig. 54,
through hole (B) in the front the saw table and then
through the hole (E) in the switch bracket. Place a 3/8"
Flat Washer (G), then a 3/8" Lockwasher (H), onto the
screw (F). Then thread a 3/8-16 Hex Nut (J) onto the
screw and tighten securely.
Fig. 54
F
B
E
G
J
H
STARTING AND STOPPING SAW
MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION BEFORE PLUGGING CORD INTO
OUTLET. DO NOT TOUCH THE PLUG’S METAL PRONGS WHEN UNPLUGGING OR PLUGGING IN THE CORD.
1. The ON/OFF switch is located underneath the switch shield (A) Fig. 55. To turn the saw “ON”, move
switch lever (B) to the up position.
2. To turn the saw “OFF”, push down on switch shield (A) Fig. 56.
LOCKING SWITCH IN THE “OFF” POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the “OFF” position to prevent
unauthorized use,
using a padlock (C) Fig. 57 with a 3/16"
diameter shackle (D).
IN THE EVENT OF A POWER OUTAGE
(SUCH AS A BREAKER OR FUSE
TRIP), ALWAYS MOVE THE SWITCH TO THE “OFF”
POSITION UNTIL THE MAIN POWER IS RESTORED.
OPERATION
Fig. 55
A
B
Fig. 56
A
Fig. 57
C
D
OPERATIONAL CONTROLS AND ADJUSTMENTS
21
