23
Fig. 63
Fig. 64
A
B
C
D
E
ASSEMBLING MITER GAUGE
Place a flat washer (A) Fig. 62 on the threads of the miter
gauge lock handle (B) and then thread the handle into
the hole (C) in miter gauge bar.
Insert washer (D) Fig. 64 into the miter gage slot (E) and
slide miter gauge onto saw table.
MITER GAUGE OPERATION AND
ADJUSTMENT
The miter gauge is equipped with adjustable index stops
at 90, 75, 60, 45 and 30 degrees.
To rotate the miter gauge, loosen lock knob (A) Fig. 63,
push the thumb lever (B) down and move the body of the
miter gage (C) to the desired angle.
The miter gauge is equipped with a washer (D) Fig. 64
which fits into the T-Slot groove (E) in the table. This
allows the miter gauge to be pulled off the front edge of
the table without falling. This allows for a longer cut-off
capacity in front of the blade.
Fig. 62
C
A
B
ADJUSTING TABLE INSERT
DISCONNECT MACHINE FROM POWER
SOURCE.
Place a straight edge across the table at both ends of
the table insert (A) Fig. 65.
THE TABLE INSERT (A) SHOULD
ALWAYS BE LEVEL WITH THE TABLE.
If an adjustment is necessary, turn the adjusting screws
(B), as needed. The table insert is equipped with a finger
hole (C) for easy removal.
Fig. 65
C
B
B
A
